No content of this site may be duplicated without written permission.
|
|
A cable lift done up by Sagnor.
Sagnor reworked my cable car and made a pretty cool cable lift out of it. It uses a func_door
and a trigger_multiple to move it. The cable can be resized to suit your needs.
Created by: Sagnor
|
|
|
A set of 2 ladders for you...
nsw Ladder 1: A ladder designed on a stack of half circle rungs coming
out of the climbed wall. A nice tech look to them.
Can copy and paste addition rungs for extended height.
Appropriate surface attributes utilized.
nsw Ladder 2: A fairly standard ladder, with an addition of loops anchoring
over the top holding it in place.
Appropriate surface attributes utilized.
Created by: Noel Weer
|
|
|
Cable car that's about the same as the one I created below. Except that this one travels on track
in the ceiling instead of along a cable. The track is 640 units long.
It can be resized to suit the distance you want it to travel.
Keep an eye on the path_corners for the train though. They need to be
set so the bottom of the car meets the floor/walkway on both sides.
Created by: AzrKnight
|
|
|
Cable car similar to the one seen in Q2DM2.
Uses a func_train and travels back and forth. Used for crossing
a large area. The cable (including connectors) is 640 units long.
It can be resized to suit the distance you want it to travel.
Keep an eye on the path_corners for the train though. They need to be
set so the bottom of the car meets the floor/walkway on both sides.
Created by: AzrKnight
|
|
|
|