Post a reply

Write your message and submit
Are you human or robot? If you have trouble, mail to spirit åt quaddicted døt c

Checking if this is requested by a real person and not an automated program.

Go back

Topic review (newest first)

2020-10-10 18:11:20

Thanks for the replies! +skill 2 works in a shortcut if it is before -game or +map.

2020-10-10 07:23:20

Try putting the skill as first + command. The order is important.

2020-10-10 04:47:27

As far as I know, skill level can not be set through a command line argument. If you are going for skill 2 as default, you should add it as a line to an autoexec.cfg (must be created from scratch, if not used before) or the quake.rc file residing in id1/pak0.pak. Otherwise, you can always load up the map, type 'skill 2' in the console followed by 'restart' to reload the level in question at skill 2.

2020-10-10 00:07:44

For any Quake maps that don't run with the injector (the very few of them), I just set up shortcuts to play them and type into the shortcut entry C:etc\Quake -game or +map as the case may be. It works fine. But when I add +skill 2 to the command, it doesn't seem to make a difference. I can get in game and the tab button says that the skill is set to 2, but the monster count is the same for maps where I know it's different (tested on e1m1), so it's obviously still on default skill 1 despite what tab shows. What can I do to get on skill 2 or 3 for real? I would just use the hub to select skill if I had to but these are single maps that don't have a hub world. Using Windows 10 and I also tried skill 2 and -skill 2 but this didn't work.

Board footer